Fatigue Design Procedure for Welded Hollow Section Joints: Recommendations of IIW Subcommission XV-E (Woodhead Publishing Series in Welding and Other Joining Technologies) - Softcover

9781855735224: Fatigue Design Procedure for Welded Hollow Section Joints: Recommendations of IIW Subcommission XV-E (Woodhead Publishing Series in Welding and Other Joining Technologies)

Softcover

ISBN 10: 1855735229 ISBN 13: 9781855735224

Publisher: Woodhead Publishing, 2000

This International Institute of Welding (IIW) report was presented at the 52nd Annual Assembly in Lisbon in June 1999. It contains recommendations representing a consensus on international best practice, focusing on a 'hot spot stress' approach.

A wide range of joint types is covered, the new fatigue design curve for both RHS and CHS is dealt with and detailed values for stress concentration factors are provided.

The purpose of this current IIW document is to serve both as an International Standards Organisation (ISO) draft specification and as a model standard for national and regional specifications worldwide.

The Recommendations (Part one) and Commentary (Part two) were edited by Dr X-L Zhao of Monash University, Australia and Professor J A Packer of the University of Toronto, Canada.

"synopsis" may belong to another edition of this title.

From the Publisher

Part 1: Recommendations Part 2: Commentary Part 1: Recommendations

Scope and General - Scope - Referenced Documents - Definitions - Notation - Materials - Types of joints - Fatigue damage accumulation - Partial safety factor

Fatigue Design Procedures - Hot spot stress method - Design procedures

Fatigue Strength - Member forces - Nominal stress ranges - SCF calculations - Hot spot stress ranges - Fatigue strength curves

SCF Calculations for CHS Joints - Uniplanar CHS T and Y-joints - Uniplanar CHS X-joints - Uniplanar CHS K-joints with gap - Multiplanar CHS XX-joints - Multiplanar CHS KK-joints with gap - Minimum SCF values

SCF Calculations for RHS Joints - Uniplanar RHS T and X-joints - Uniplanar RHS K-joints with gap - Uniplanar RHS K-joints with overlap - Multiplanar RHS KK-joints with gap - Minimum SCF values

Appendices - Quality requirements for hollow sections - Weld details - A fatigue assessment procedure - SCF formulae and graphs for CHS joints - SCF formulae and graphs for RHS joints Part 2: Commentary

"About this title" may belong to another edition of this title.